Loading... Please wait...How Often to Change Machine Coolant and Filters
|
Changing Machine Coolant Machine coolant should probably be changed once a year. Some folks do it every six months and some do it every other year. More than twice a year is generally excessive. For more information on Filter units, and how to change them refer to our Filtering Machine Coolant Index.
Reasons to Change Filters Monthly Your Machine Coolant Filter Unit from Carbide Processors is designed for monthly filter changes. You can go two or three months between filter changes if you wish. However if you go longer than one month then the filters become very hard to change. At one month you just pull the old filters out and put new ones in. It takes a few minutes. If you go three months you will pack three times the oil, grease and ground carbide in the filter housings and it will be very hard to remove. |
Old filter left and new filter right showing how much oil and grease the CP filter unit traps. |
|
One Month Five Easy Minutes |
Two Months or More Up To Twenty Minutes of Hard Dirty Work
|
|
The filters slide or pull out easily.
|
You get a cake like hard packed clay surrounding the filter making it impossible to remove until you dig the cake out. Digging the filter out can take up to twenty minutes and it is messy, unpleasant work. |
|
|
 |
All prices are in USD Copyright 2025 Carbide Processors. Sitemap | Website by oBundle
e, but the one adaptor allows me to use annual cutters in an older mag drill, several different drill presses and milling machines without having to own separate adaptors with shanks that match several morse taper sizes and R8 tooling. Read LessRead less about This is a well machined adaptor that
e Ridgid cast iron table and the Incra fence per the Incra directions. It all works really well. The set up took a little while but it’s sweet! I have done probably 50 cuts and each time I measure with a caliper and it’s dead on front to back on the board I am cutting. I think I am within .004 between blade and fence discrepancies. So for a Ridgid R4512 I’ll take it. Now I have a $1000 package that can hang in terms of accuracy with a nicer cabinet saw. Read LessRead less about So I added the TS-LS 32” to my
, the deal was too good to ignore and figured I would challenge any irregularities with the credit card company later. I also located a coupon code that made the price unbeatable. It must be stated, the expected delivery time on this particular unit was 6 weeks out, adding to my concern. This is the same time frame advised on the Incra web site as well. At probably 5 weeks, I was thrilled to receive delivery notice emails. The large unit came in pristine condition and packaged extremely well. I WILL NOT HESITATE TO BUY FROM CARBIDE PROCESSORS IN THE FUTURE. Thank you for the fantastic deal! Read LessRead less about I had been looking for several weeks
