Vortex 3pc Router Bit Set, 2 Flute, 1/4" dia, Upcut, Downcut and Compression, Vortex 314

This 3pc Vortex Spiral Router Bit set includes 1/4" upcut spiral bit, 1/4" downcut spiral bit, and 1/4" compression spiral bit and is sold Exclusively at Carbide Processors. Get incredibly clean, splinter-free cutting with these high quality bits.  Get upcut, downcut, and compression style spirals all in one convenient set.  Set includese Vortex 1230, 3112, and 1330. 

Includes:

1230- 1/4″ Cutting Diameter, Cutting Edge Length 7/8″, Shank Diameter 1/4″, Overall Length 2-1/2″

1330-1/4″ Cutting Diameter, Cutting Edge Length 7/8″, Shank Diameter 1/4″, Overall Length 2-1/2″

3112- 1/4″ Cutting Diameter, Cutting Edge Length 7/8″, Shank Diameter 1/4″, Overall Length 3″

Downcut tools are used where the downshearing effect of the tool is preferred. This tool will produce a clean top edge cut of dado type or groove type cut or a simple thru-cut where the bottom edge cut quality is not important. Downshear bits direct chip flow downward and help hold the part onto the table or pods. 

Compression Spirals have an "up-cut/downcut" design and will give you a nice clean cut on both the top and bottom of material with no splintering or tear out.

The upcut spiral will provide a smooth bottom finish, while augering the chips upward. Due to the upcut design and the included angle of the cutting edge, these tools are razor sharp!

Vortex Tool Company router bits, boring bits and CNC tooling are proudly made in the USA.

*Please note that the above picture is a representation of the type of tool and may not accurately represent the actual size and dimensions.

WARNING: Cancer and Reproductive Harm—www.P65Warnings.ca.gov