The concept is to build extremely efficient units that sell for as little as possible.
We have done our best to design sturdy and reliable filter units that work well and cost less. For more information on how our filter units work and why Filtering Machine Coolant is Important refer back to our Filtration Index.
|
|
|
Wall Mount for Straight Oil $895 |
Wall Mount for Water Based or Straight Oils $695 |
Complete 2002 unit for Water Based $2038 |
Nothing Tells the Story Like Real Numbers
Below you can see that our units are incredibly effective in spite of their low cost.
Straight Oil Coolant |
Water Based Coolant |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
Notes:
1. The laser approximates counts and then uses algorithms to estimate total number of particles which accounts for the unusual results such as the repetition of 44,906.
2. With the cloth filters you get a replacement of hard carbide and diamond particles with cloth particles since the hard grit abrades the softer cloth.
3. The best and most comprehensive studies of this that I have seen were done by Boeing aircraft. Their standard is that you should remove particles down to 10% of the tightest dimension. If you grind to 0.001” then you are concerned about anything larger than 2.5 microns.
4. At this level of filtering you are also removing tramp oils and greases since they naturally form larger globules than grinding oils.
5. Many individual bacteria and fungi are one micron or larger. They all form colonies large enough to be filtered out at this level.
6. The laboratory is Spectra Labs in Tacoma, WA.
All prices are in USD Copyright 2025 Carbide Processors. Sitemap | Website by oBundle
e, but the one adaptor allows me to use annual cutters in an older mag drill, several different drill presses and milling machines without having to own separate adaptors with shanks that match several morse taper sizes and R8 tooling. Read LessRead less about This is a well machined adaptor that
e Ridgid cast iron table and the Incra fence per the Incra directions. It all works really well. The set up took a little while but it’s sweet! I have done probably 50 cuts and each time I measure with a caliper and it’s dead on front to back on the board I am cutting. I think I am within .004 between blade and fence discrepancies. So for a Ridgid R4512 I’ll take it. Now I have a $1000 package that can hang in terms of accuracy with a nicer cabinet saw. Read LessRead less about So I added the TS-LS 32” to my
, the deal was too good to ignore and figured I would challenge any irregularities with the credit card company later. I also located a coupon code that made the price unbeatable. It must be stated, the expected delivery time on this particular unit was 6 weeks out, adding to my concern. This is the same time frame advised on the Incra web site as well. At probably 5 weeks, I was thrilled to receive delivery notice emails. The large unit came in pristine condition and packaged extremely well. I WILL NOT HESITATE TO BUY FROM CARBIDE PROCESSORS IN THE FUTURE. Thank you for the fantastic deal! Read LessRead less about I had been looking for several weeks