Handrail Router Bit, 1-1/2 Cut Length, 1/2 Shank, Whiteside 3304

**This item has been discontinued by the manufacturer. Please see Whiteside 3305 for the closest available alternative.**

Hand Rail, Router Bits (Used To Cut The Lower Portion Of The Hand Rail Profile) - 1/2" Shank, Carbide Tipped - Whiteside 3304;
1-3/8" Large Diameter, 1-1/2" Cutting Length, 1/4" Bead Diameter, 3-3/8" Overall Length, Bearing Number: B3

Whiteside Machine is regularly rated as #1 for cut quality and #1 for value by Fine Woodworking magazine.

Whiteside Machine was originally a machine shop, many decades ago. They were machining precision router bodies for a customer. The customer went broke leaving them sitting on the router bodies so they decide to finish them and sell them. This is a real story of courage, resourcefulness, guts and just plain stubbornness.

Decades later they are still stubborn about absolutely top quality and beautiful tools.

Braze tools ( CT carbide tipped or TCT Tungsten Carbide Tipped ) Have a piece of expensive tungsten carbide brazed to a steel shaft. This gives you the incredible long wear of carbide (up to 100 times that of steel) and the toughness of a steel saw plate, router shaft, etc. It makes a clearly superior tool at a greatly reduced cost.

*Please note that the above picture is a representation of the type of tool and may not accurately represent the actual size and dimensions.

WARNING: Cancer and Reproductive Harm—www.P65Warnings.ca.gov