This is a well machined adaptor that accepts 3/4" Weldon Shank annular cutters. The adaptors 1/2" shank is machined to accept cutter center pin and includes a spring for pin retraction during cut and plug ejection. This adaptor allows me to use annular cutters in any standard drill chuck with 1/2" or greater capacity. The adaptor is not inexpensive, but the one adaptor allows me to use annual cutters in an older mag drill, several different drill presses and milling machines without having to own separate adaptors with shanks that match several morse taper sizes and R8 tooling.

So I added the TS-LS 32” to my relatively new Ridgid R4512 table saw. The Ridgid fence was terrible. I almost scrapped the whole saw. But the Incra fence is great. I didn’t have to drill any holes and just got rid of the metal cast iron extension wings that were not level. I built plywood pretty accurate wings to fit into the TS-LS gaps between the Ridgid cast iron table and the Incra fence per the Incra directions. It all works really well. The set up took a little while but it’s sweet! I have done probably 50 cuts and each time I measure with a caliper and it’s dead on front to back on the board I am cutting. I think I am within .004 between blade and fence discrepancies. So for a Ridgid R4512 I’ll take it. Now I have a $1000 package that can hang in terms of accuracy with a nicer cabinet saw.

I had been looking for several weeks to find a good deal on this Incra table saw fence and router system. I noticed Carbide Processors on the countless Google searches for price comparisons. Frankly, their price was lower than any other retailer. But I had never heard of this company and was weary to throw a large sum of money on a gamble. However, the deal was too good to ignore and figured I would challenge any irregularities with the credit card company later. I also located a coupon code that made the price unbeatable. It must be stated, the expected delivery time on this particular unit was 6 weeks out, adding to my concern. This is the same time frame advised on the Incra web site as well. At probably 5 weeks, I was thrilled to receive delivery notice emails. The large unit came in pristine condition and packaged extremely well. I WILL NOT HESITATE TO BUY FROM CARBIDE PROCESSORS IN THE FUTURE. Thank you for the fantastic deal!

Incra CleanSweep was fairly easy to install after I ordered the attachment plate. CleanSweep works as I had hoped it would in combination with the Clean Sweep rings.